Skip to Content
Support
Brisk Air ConditionersHow to control “AUTO” - Auto Change Over Mode (COMFORT CONTROL CENTER 2 THERMOSTAT)
Brisk Air Conditioners

Brisk Air Conditioners

How to control “AUTO” - Auto Change Over Mode (COMFORT CONTROL CENTER 2 THERMOSTAT)

In the AUTO mode the system will automatically change the mode of operation from cool to heat or from heat to cool. In order for this mode to operate, the zone being programmed must contain either a heat pump, heat strip or furnace heating source.

When in the AUTO mode, all pre-programmed operations for the heat pump, heat strip, and furnace will apply. Auto Change Over Cooling: If the room temperature rises above the temperature set-point by 2 °F / °C, the air conditioner will turn ON until the room temperature reaches the temperature set-point at which time the air conditioner will cycle OFF.

Auto Change Over Heating: If the room temperature goes below the temperature set-point by 2 °F / °C, the available heat source will be cycled ON until the room temperature reaches the temperature set point at which time it will cycle OFF. If more than one heat source is available on this zone, the priority for selecting the heat source will be heat pump (first), furnace (second), and heat strip (third).

Avete bisogno di ulteriore aiuto?

Porre una domanda diversaBrisk Air Conditioners
Selezionare un altro prodotto
Sitemap
SupportSupport & ServiceFrequently asked questionsWarrantyFind a dealer
Privacy PolicyCookie NoticeTerms & ConditionsTerms of Use