Skip to Content
Support
On Demand Water Heater (OD-5001)Low Heat Rise and Excessive Water Flow Is Required To Trigger Water Heater

On Demand Water Heater (OD-5001)

Low Heat Rise and Excessive Water Flow Is Required To Trigger Water Heater

Prova questa soluzione

Check that valves and faucets are closed when not in use

If you find that your heater requires excessive flow to activate it (much over .5 gallon per minute), it is likely that you have cold water bleeding into the hot water side
of your water system.

Check that valves and faucets are closed when not in use. If there is an on/off button on your showerhead, always turn the water valves off after the shower to prevent cold water from bleeding into the hot water system. This will keep the heater from functioning properly.

Avete bisogno di ulteriore aiuto?

Porre una domanda diversaOn Demand Water Heater (OD-5001)
Selezionare un altro prodotto
In questa pagina
Sitemap
SupportSupport & ServiceFrequently asked questionsWarrantyFind a dealer
Privacy PolicyCookie NoticeTerms & ConditionsTerms of Use