Skip to Content
On Demand Water Heater (OD-5001)Low Heat Rise and Excessive Water Flow Is Required To Trigger Water Heater
On Demand Water Heater (OD-5001)
Low Heat Rise and Excessive Water Flow Is Required To Trigger Water Heater
Prova den här lösningen
Check that valves and faucets are closed when not in use
If you find that your heater requires excessive flow to activate it (much over .5 gallon per minute), it is likely that you have cold water bleeding into the hot water side
of your water system.
Check that valves and faucets are closed when not in use. If there is an on/off button on your showerhead, always turn the water valves off after the shower to prevent cold water from bleeding into the hot water system. This will keep the heater from functioning properly.
Behöver du mer hjälp?
Innehåll